Skip to content

SI21-D5-R75G-A Veichi SI21-D5 Solar Pump Inverter | 0.75 kW (3-phase/380V-460VAC)

Є в наявності
sku: SI21-D5-R75G-A
SI21-D5-R75G-A Veichi SI21-D5 Solar Pump Inverter | 0.75 kW (3-phase/380V-460VAC)
Клікніть для збільшення
Veichi
Є в наявності
9 452 UAH
Brand: Veichi
Seriya: SI21
Power: 0.7 kW

delivery-iconDelivery and payment methods

  • Nova Poshta OfficeBy Nova Poshta to a branch or courier to the address
  • OplataBank transfer payment

delivery-iconService and Warranty

  • 24-month Warranty
  • Product return within 14 days
  • Official Service Center

delivery-iconTechnical support

  • Help with setup and selection
  • Зацікавив товар?
    Наш продавець проконсультує Вас.
  • Characteristics
  • Description
  • Documentation
  • Reviews (1)
Brand Veichi
Seriya SI21
sku SI21-D5-R75G-A
Power 0.7 kW
Power supply 3-ф/380
power_output 3-ф/380
Mmax 150
In_A 3
f_max_Hz 600
IP IP20
EMC_filtr No
size_height_mm 200
size_width_mm 76
size_depth_mm 155
inbuilt_plc Available
regulator PID
control_scalar Available
control_vector_without_PG Available
law_U_f Available
law_U_f2 Available
Video Thumbnail
Video Thumbnail
Video Thumbnail
Documents by language

Ukrainian / English / Russian

Chastotnik.ua

Practical setup guides

Chastotnik.ua materials for wiring and setup. These are not official manufacturer documents.

Guide Replacing a European VFD with Veichi: NPN/PNP, PLC jumper, COM vs GND The most common scenario when replacing a European drive (Schneider Altivar, Siemens, LS, Danfoss) with Veichi looks like this: the power section is w... Go to Guide COM or GND: why the buttons do not work on a Veichi VFD A typical picture after installation: the Veichi VFD starts from the keypad, the parameters are entered, but the external Start/Stop buttons produce n... Go to Guide PLC jumper on Veichi: wiring PNP/NPN sensors and pushbuttons On the control board of Veichi AC10 (from 7.5 kW) and AC310 three terminals sit side by side: +24V, PLC and COM. Between them is a small jumper. Its p... Go to Guide VFD grounding and stray voltage on the enclosure (PE, >5V) A fairly common complaint after installation: voltage "tingles" on the motor housing, the cabinet or the drive itself, while the keypad or sensors sta... Go to Guide Shielding a 4-20mA sensor: which end to ground, 15 cm separation A pressure or flow sensor in pump automation almost always outputs a 4-20 mA current signal. On Veichi it is wired to an analog input that can operate... Go to Guide Replacing a Schneider Altivar with Veichi: step-by-step terminal and parameter migration The power section of a Schneider Altivar and a Veichi is wired the same way: mains to R/S/T, motor to U/V/W, PE to the ground terminal. The difficulty... Go to
Product Reviews
1
5 1
4 0
3 0
2 0
1 0
Михайло, фермер
30.07.2025

Шукав рішення для поливу на полях, де електрики немає взагалі. Мені порадили цей сонячний інвертор Veichi SI21-D5-R75G-A. Поставив його з панелями на 0.75 кВт, і тепер насос для свердловини працює від сонця без проблем. Що класно, він сам собі шукає оптимальну точку (той MPPT, як мені пояснили). Ще й компактний, не займає багато місця в будці. Надійна штука, виручає дуже!

This page contains information about Veichi SI21-D5 Solar Pump Inverter | 0.75 kW (3-phase/380V-460VAC) ( SI21-D5-R75G-A ) with a detailed description of the technical characteristics . You can download documentation for SI21-D5-R75G-A, series SI21 from manufacturer Veichi . Buy SI21D5R75GA and seek technical advice. Our Engineers will help you choose and buy SI21-D5-R75G-A only high quality at affordable prices. Guarantee. SI21-D5-R75G-A