R912004563 Brake resistor 0.10 KW, 400 Ohms for EFC3600 400W, 230V 20% ED
Є в наявності
sku: R912004563
Є в наявності
823 UAH
brand: Bosch Rexroth
Series: option
option type: Тормозной резистор
Delivery and payment methods
By Nova Poshta to a branch or courier to the address
Bank transfer payment
Service and Warranty
- 24-month Warranty
- Product return within 14 days
- Official Service Center
Technical support
- Help with setup and selection
- Зацікавив товар?
Наш продавець проконсультує Вас.
- Characteristics
- Documentation
- Reviews (0)
| brand | Bosch Rexroth |
| Series | option |
| sku | R912004563 |
| option type | Тормозной резистор |
| 0,10 |
Documents by language
Ukrainian / English / Russian
EN English
Chastotnik.ua
Practical setup guides
Chastotnik.ua materials for wiring and setup. These are not official manufacturer documents.
Guide
Replacing a European VFD with Veichi: NPN/PNP, PLC jumper, COM vs GND
The most common scenario when replacing a European drive (Schneider Altivar, Siemens, LS, Danfoss) with Veichi looks like this: the power section is w...
Go to
Guide
COM or GND: why the buttons do not work on a Veichi VFD
A typical picture after installation: the Veichi VFD starts from the keypad, the parameters are entered, but the external Start/Stop buttons produce n...
Go to
Guide
PLC jumper on Veichi: wiring PNP/NPN sensors and pushbuttons
On the control board of Veichi AC10 (from 7.5 kW) and AC310 three terminals sit side by side: +24V, PLC and COM. Between them is a small jumper. Its p...
Go to
Guide
VFD grounding and stray voltage on the enclosure (PE, >5V)
A fairly common complaint after installation: voltage "tingles" on the motor housing, the cabinet or the drive itself, while the keypad or sensors sta...
Go to
Guide
Shielding a 4-20mA sensor: which end to ground, 15 cm separation
A pressure or flow sensor in pump automation almost always outputs a 4-20 mA current signal. On Veichi it is wired to an analog input that can operate...
Go to
Guide
Replacing a Schneider Altivar with Veichi: step-by-step terminal and parameter migration
The power section of a Schneider Altivar and a Veichi is wired the same way: mains to R/S/T, motor to U/V/W, PE to the ground terminal. The difficulty...
Go to
This page contains information about
Brake resistor 0.10 KW, 400 Ohms for EFC3600 400W, 230V 20% ED ( R912004563 )
with a detailed description of the technical characteristics
.
You can download
documentation for R912004563, series option from manufacturer Bosch Rexroth
.
Buy R912004563
and seek technical advice.
Our Engineers will help you choose and buy
R912004563 only high quality at affordable prices. Guarantee.
R912004563
